 1. Tape the covers to your RV where they should go. Use masking tape that easily comes off and won't leave glue on your rig in the hot weather. |
|
|
 2. Mark the back of the top-center snap (the female snap on the cover) with chalk, crayon or pencil. |
|
|
 3. Press the snap on the cover against the fiberglass. |
|
|
 4. It will leave a "ring" from the chalk, crayon or pencil. |
|
|
 5. In the center of the Òring," make a 1/4" deep pilot hole using a 1/8" drill bit. |
|
|
 6. Countersink the hole and fill it with silicone as seen in the next 4 photos... |
|
|
 7. To countersink you could use a large drill bit, if you wish. |
|
|
 7. It should look like this. |
|
|
 9. Silicone goes here. |
|
|
 10. Using a Phillips screwdriver, screw the male snap into the rig. |
|
|
 11. Mount the bottom-center fastener, then the four corner fasteners. Mount the side covers in the same way. |
|
|
